3.5.8.
46
If the distance between the material and the jaw is too small, it may cause
problems with the material feed (the friction of the jaws against material may
occur).
Feeding step adjustment
The saw Ergonomic 290.250 GAC does not have feeder equipped with
indicator of the hydraulic cylinder position, but with an adjustable cylinder
position, it is necessary to adjust the length of the feeding step manually.
1.
Release the securing lever of the feeder cube. The lever is placed under
the level of the roller conveyor.
2.
Drive with the cylinder to desired position by turning with the circular
handle of the travel screw.
Attention!
You can measure the correctness of the adjustment from
the scale. The scale is located on the hydraulic cylinder.
Manual version: 1.02 / Mar. 2010
Manual rev.:
1