Bomar Ergonomic Automat Series Operating Instruction page 10

1.1.
1.2.
10
The operating instructions must be read by the person, who keeps in touch
with the machine before transportation, installation, using, servicing,
reparation, stocking or removal!
The operating instructions include relevant information. The operator must
familiarise himself with the install and operation, safety notes and machine
servicing, because reliability and service life must be reached. The operating
instructions must avoid risks, which are linked to work on the machine. Before
transporting and using of the machine, please read the instructions thoroughly!
The operating instructions must be available at the machine! Keep the
operating instructions in good condition!
Attention!
The exclamation mark in the yellow triangle signifies a
safety warning. The meaning is described next to the
symbol.
Band saw using
Band saw Ergonomic 320.250 GAC is used for cutting and shortening of
rolled bars and drawn bars and profiles from steels, stainless steels, non-
ferrous metals and plastics with angle cutting from 0° to 60°.
Combustible materials are excepted for cutting! Any other usage and
operation outside this range are unauthorised and the manufacturer/supplier
does not accept any responsibility for any damages resulting from such
misuse. The operator has full responsibility!
The machine is equipped with safety and protective guarding for operator and
machine protection. Nevertheless, this safety and protective guarding cannot
prevent injury. Service personnel must read this chapter and comprehend it,
before he starts to work on the machine. Always keep instructions about
work safety! Service personnel must take into account other aspects of the
risk, which refer to the ambient conditions and the material.
Attention!
Consider the safety signs on the machine. Do not remove
or damage them!
Protective suit and personal safety
Wear tight fitting overalls! Loose fitting clothes may be caught with machine
parts and cause serious injury.
Wear protective gloves! Material cuts and saw band have sharp edges and
may cause serious injuries.
Attention!
Gloves you can use only at working material replacement
(saw band)! The machine and accessories must be
inactive!
If the machine is running, you must not wear gloves! It is
dangerous, because some parts of the machine can catch
gloves!
Wear protective shoes with non-skid soles! The unsuitable shoes may
cause balance loss and following injury. Falling work pieces may cause
serious injuries too.
Wear protective goggles! Chips and cooling liquid may damage your eyes.
Always wear ear protections! Most of the machines emit up to 80 dB and
may damage your hearing.
Manual version: 1.02 / Mar. 2010
Manual rev.: 1