Bomar Ergonomic Automat Series Operating Instruction page 22

2.4.
2.4.1.
2.4.2.
2.4.3.
22
Transportation and stocking
Conditions for transportation and stocking
Keep recommendations for the manufacturers for transportation and stocking!
If the recommendations are not kept, damage can occur to the machine.
•
Don't use a forklift truck for handling the machine, if you do not have
license for it!
•
Don't move under suspended loads! Fault in lifting device may cause
serious injury.
•
Keep a safe distance from the machine during the transport.
•
Temperature of the air from -25°C to 55°C, for a short term (max. 24
hours) temperature of the air until 70°C
•
Do not expose the machine to radiation (for example microwave radiation,
ultraviolet radiation, laser radiation, x-ray radiation). Radiation can cause
problems with the machine function and deteriorating condition of the
isolation.
•
Take measures, to prevent damage by dampness, by vibrations and by
shakes.
Transport and stocking preparations
Close the vice and thoroughly oil all blank surfaces.
Lower the saw frame to the lowest position.
Make sure to empty the machine of all traces of the cooling agent.
Fasten all loose parts securely to the machine.
Pack and wrap the control desk securely to avoid damage during transport.
Fix the stickers stating the minimum approximate machine weight to at least
five well visible places.
Transport and stocking
The machine must be secured during transportation. Screw on the palette to
the floor of the van or the trailer. Be careful that the machine is not damaged
during transportation. Store the machine only under conditions mentioned in
the manual, to avoid damage of the machine.
t is forbidden to handle the machine any other way, than it is written in this
operating instructions, the machine can be damaged.
Manual version: 1.02 / Mar. 2010
Manual rev.: 1