Bomar Ergonomic Automat Series Operating Instruction page 31

3.1. Control panel
C button
C
It is used for deleting of the set value.
E button
E
It is used for confirming of the set value.
F1 – Functional button
F1
Button function is described below in the text.
F2 – Functional button
F2
Button function is described below in the text.
F3 – Functional button
F3
Button function is described below in the text.
F4 – Functional button
F4
Button function is described below in the text.
0
Switch off the band engine
1
Feeder to the forward position
2
Clamp the feeding vice
3
Clamp the main vice
4
Lift the saw arm up
5
Switch on the band engine
6
Feeder to the rear position
7
Open the feeding vice
8
Open the main vice
9
Lower the saw arm down
Switch on the safety circuit
10
Switch on the safety circuit by pressing button.
Cooling system selection
You can select from three possibilities:
Cooling with Microniser
11
0
Without cooling
Cooling with water
31