Bomar Ergonomic Automat Series Operating Instruction page 24

2.5.
2.5.1.
2.6.
2.6.1.
2.6.2.
24
Activation
Machine working conditions
Keep the conditions of the manufacturer for machine operating! If
recommendations are not kept, damage can occur to the machine.
The manufacturer warrants the correct function of the machine for these
conditions:
•
At temperature air from 5°C to 40°C, the temperature average during 24
hours must not exceed over 35°C.
•
At relative dampness of the air in the extend from 30% to 95% (not
concentrate)
•
Altitude lower than 1000 metres.
•
Do not expose the machine to the radiation (for example microwave
radiation, ultra-violet radiation, laser radiation, x-ray radiation). Radiation
can cause problems with the machine function and deteriorating condition
of the isolation.
Band saw unpacking and assembling
Remove the packing from the machine and unpack all parts.
Attention!
Switch off the main switch and lock it, before you start
assembly! Otherwise, there is possibility of hazardous
machine starting.
Machine installing and levelling
Check the floor supporting capacity before machine installing. If the floor
capacity does not agree with requirements, you must prepare the necessary
base for the machine.
Minimal requirement:
machine weight –
Ergonomic 320.250 GAC – 565 kg
+ weight of accessories
+ maximum weight of material
•
The machine must be levelled at the horizontal position. All feet of the
machine must touch with the floor after levelling
•
The machine must be levelled by means of the calibrated spirit level. Spirit
level is put on the vice area. Set the roller conveyors according to the spirit
level.
•
For machine levelling, take care that there is sufficient available space for
operation, repair work, servicing of the machine and handling the
material..
•
The machine including appended parts and accessories must be visible
from the place of operation.
Machine disposal after lifetime
Blown out all service fluids (cooling liquid, hydraulic oil) into designated
reservoir. Dismantle machine into separate parts and dispose them in
accordance with valid directives.
Manual version: 1.02 / Mar. 2010
Manual rev.: 1