Bomar Ergonomic Automat Series Operating Instruction page 11

Do not wear jewellery and always tie back long hair! Moving machine parts
can catch jewellery or loose hair and may cause serious injuries.
Operate the machine only when you are fit enough to work. Illnesses or
injuries diminish concentration. Avoid machine work, which may compromise
the safety of you and your colleagues!
1.3. Safety notes for machine operator
Attention!
Machine can be operated by person older than 18 years!
Machine can be operated only person physically and
mentally fit for this activity
Machine can be operated only by one person. Machine operator is
responsible for presence of other persons by the machine.
Keep instructions and orders about work safety!
Read the operating instructions, before you start to work
on the machine! Keep the operating instructions in good
condition!
Attention!
Do not connect the machine to electricity if the covers
are removed. Do not touch the electrical equipment.
Close covers before the machine starting and check, if the covers are not
damaged. Damaged covers must be repaired or changed. Do not start the
machine, if the cover is removed! Check, if the electric cables are not
damaged.
•
Do not hold the material for clamping to the vice and for cutting!
•
Do not operate with the buttons and the switches on the control panel,
when you have gloves!
•
For machine starting take care, that there is nobody in the working area of
the machine (it means in the working area of the vice, the saw band, the
saw arm etc.).
•
In no circumstances touch the rotating elements.
•
Work on the machine only when the machine is in good condition!
•
Check at least once in a shift, if the machine is not damaged. If the
machine is damaged, you must bring the machine in order and you must
inform your superior!
•
Keep your working area clean! Ensure sufficient lighting in the working
area.
•
Take off the spilt water or the oil from the floor and dry it. Do not touch the
cooling liquid with bare hands! Do not set the nozzle of the cooling liquid,
when the machine is started on
•
Do not remove the chips from the working area of the machine, when the
machine is started on!
•
Do not use the compressed air for the machine cleaning or for the chips
removing!
11