Komatsu PC88MR-10 Shop Manual page 1033

Marks used in the section of "Disassembly" are
explained below.
: This mark shows safety-related precautions
which must be followed when performing the
work.
a : This mark gives knowledge or precautions
when performing the work.
: This mark shows the amount of oil or
coolant to be drained.
: This mark shows the weight of the part
or equipment.
Assembly
"Assembly" describes the work procedure as
well as the precautions, knowledge, and drain
amounts of oil and water required for the work.
The general tools required for "Assembly" are
listed as [1], [2], ..., without description of part
number, part name, and quantity.
Marks used in the section of "Assembly" are
explained below.
: This mark shows safety-related precautions
which must be followed when performing the
work.
a : This mark gives knowledge or precautions
when performing the work.
: This mark shows the weight of the part
or equipment.
: This mark shows a specific coating
agent to be used.
: This mark shows the specified
tightening torque.
: This mark shows the amount of oil or
coolant to be added.
For details of oil or coolant to be
added after installation, see
Specification "Table of fuel, coolant
and lubricants".
PC88MR-10
50 Disassembly and assembly
Related information on disassembly and assembly
50-5