Komatsu PC88MR-10 Shop Manual page 1192

50 Disassembly and assembly
Work equipment
[*2]
Mounting pin sliding surface (when
assembling)
Hyper white grease (G2-T)
Mounting pin (greasing after
assembly)
Hyper white grease (G2-T)
When aligning pin holes, never insert
your finger into the holes.
Be sure to insert shim to (b) and (c) parts of
the clearance between boom (28) and
bracket (29).
Shim thickness for (b) part insertion: t =
1.0mm
Shim thickness for (c) part insertion: t =
1.0mm, t = 1.5mm
a Be sure to insert Min. one shim.
Refill with oil (Hydraulic tank)
Refill it with oil to the specified level through the
oil filler port. Run the engine to circulate the oil
through the piping. Then check the oil level
again.
Hydraulic oil:
56 l l (specified capacity: 100 l l )
Bleed air
Bleed air. For details, see "Testing and
adjusting", "Bleed air from each part".
50-164 PC88MR-10