Mitsubishi Electric 800 Series Manual page 105

2
Negative output selection for monitoring (Pr.290)
Negative output is available for FR Configurator2 or the trace function.
Pr.290 setting
0 (initial value) —
1 Enabled
2 —
3 Enabled
4 —
5 Enabled
6 —
7 Enabled
—: Disabled (unsigned numbers only)
*1 The following communication does not support the negative output.
RS-485 communication (Mitsubishi inverter protocol, MODBUS RTU), SLMP communication, and HMS network option
*2 Under the condition that the high-speed sampling and the negative output are selected for FR Configurator2, the display range of the
output frequency (Monitor No.1) is -300.00 Hz to 300.00 Hz. A value outside the range is clamped at -300.00 Hz or 300.00 Hz. Under
the same condition, the display range of the running speed (Monitor No.6) is -30000 r/min to 30000 r/min. A value outside the range
is clamped at -30000 r/min or 30000 r/min. During the trace sampling, the same display ranges are applied. A value outside the ranges
is clamped.
Terminal AM Operation panel
—
—
Enabled
Enabled
—
—
Enabled
Enabled
Connection port
Communication option
—
—
—
—
Enabled
Enabled
Enabled
Enabled
2
*1
FR Configurator2 etc.
—
—
—
—
Enabled
Enabled
Enabled
Enabled
BCN-C22005-855
*2