Baffle Removal; Disposal Of Ashes; Optional Blower; Removal - Pacific energy ALDERLEA T6 Installation & Operation Manual

Disposal of Ashes

Ashes should be placed in a metal container with a tight fitting lid. The closed container of
ashes should be placed outside on a non-combustible floor or on the ground, well away
from all combustible materials, pending final disposal. If the ashes are disposed of by burial
in soil or otherwise locally dispersed, they should be retained in a closed container until all
cinders have thoroughly cooled. Other waste should not be placed in this container.
Chimney connector pipe should be disconnected from stove to clean and inspect.
Only if this is not possible should you remove baffle assembly.
DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.

Removal

Remove retaining pin located at the rear top of the firebox, just below the
baffle. Lift baffle up and pull forward to disconnect from the supply tube. Tilt baffle
sideways to drop down and remove from firebox. Inspect gasket between baffle
and supply tube. If necessary, replace with gasket #3139.5 available from your
Pacific Energy dealer. Re-install baffle assembly in reverse order. The two side
pieces of insulation must be tight against the siderails.
Secondary Air Box Removal and Cleaning:
1. The secondary air box is located on the bottom rear of the woodstove and can
2. To remove the secondary air box, use a 3/8" wrench and undo the two #10 Keps
3. Reverse this process to re-install the secondary air box.
*
The optional blower kit (kit #WODC.BLOW) is equipped with a three prong power
cord and may be installed at any time. Follow installation instructions supplied with
the kit. Route power supply cord away from heater.
Electrical rating: 115 volts A.C.- 0.84 amps.
Fan output rating: 140 CFM

Blower Operation

Proper blower speed matched with air control setting will ensure peak performance
from your stove. Operate as follows:
• Air control set to low (right position), operate blower speed control on "Low".
• Air control set between low and high (middle position), operate blower
Automatic: To operate the blower automatically, set the rocker switch on the side
of the fan housing to "Auto" and set the speed control to desired setting. This will
allow the fan to turn on as the stove heats up to operating temperature. It will also
shut the blower off after the fire has gone out and the unit cooled to below a useful
heat output range.
Manual: To manually operate the blower, set the rocker switch to "Man" and set
the speed control to desired setting. This will bypass the sensing device and allow
full control of the blower.
Switching from "Auto" to "Man" or selecting speed may be done anytime.
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.

Baffle Removal

be cleaned by removing the two screws securing the cover plate on the rear
face of the secondary air box and using a vacuum to suck out any debris.
nuts, one on each side of the secondary air box. Lower the secondary air box
and slide out.
MAKE SURE THE GASKET IS IN GOOD SHAPE AND POSITIONED
CORRECTLY.

Optional Blower

speed control at desired setting.
16
190617-24 AL6B