Table of Contents
Advertisement
9. Be aware that the hotter the fire, the less creosote is deposited. Weekly cleaning may be necessary in mild weather,
even though monthly cleaning is usually enough in the coldest months when burning rates are higher.
10. Instruct all members of your family on the safe operation of the heater. Ensure they have enough knowledge of the
entire system if they are expected to operate it. Stress the section on chimney fires and the importance of following
the steps outlined "In Case of Chimney Fire".
Baffle Removal
Chimney connector pipe should be disconnected from stove to clean and inspect. Only if this is not possible should you
remove baffle assembly. CAUTION: Ceramic blanket insulation is located on top of baffle. Do not use a vacuum in this
area.
DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.
Remove the retaining pin at the back of the firebox, just under the baffle. Lift baffle up on one side and remove the cor-
responding brick rail by lifting up and off the mounting pins. Lift the entire Baffle up and pull forward to disconnect from
the supply tube. Tilt baffle sideways to drop down and remove from firebox. Re-install baffle assembly in reverse order.
WARNING Sweep/Clean chimney with baffle installed or be sure to plug the top of the baffle tube in the back of the
firebox before sweeping or cleaning. Failure to prevent ash or soot from falling into the baffle tube will cause incorrect
operation and will lead to premature burn out of the tube or baffle.
Check the following parts for damage such as cracks, excessive corrosion, burned out sections and excessive warping:
(See website for descriptions and more detail)
Some warping of the baffle is normal(up to 1/4" or .65cm). Replace if the baffle has permanent warping greater than this
or has signs of cracking or breakage.
Weekly:
- Firebrick - for cracking. - Door Gasket - sagging, placement, damage.
Monthly:
- Brick rail tabs and brick rails. - Air riser tube in the back of the firebox.
- Back side of airwash chamber - located in the upper front of firebox.
- Baffle locking pin.
- Boost tube cover - located in center of manifold, bottom front of firebox.
When Cleaning the Chimney System:
- Top baffle board/blanket.
- Baffle.
- Brick Rails.
- Manifold - located in bottom front of firebox.
Blower:
•
The blower should be cleaned out a minimum every six months by using a vacuum on the grill openings in the back
and bottom of the blower casing to remove any dust and debris.
•
Please contact your dealer if you experience any of the damage listed above. Continuing to operate your stove with
broken parts may accelerate damage to other parts and may void your warranty.
210618-28_ALT 1.2
Maintenance Checks
9
5055.7298-A
Advertisement
Table of Contents
