Pacific energy Alderlea T5 Classic Insert Installation And Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Pacific energy Manuals
  4. Wood stove
  5. Alderlea T5 Classic Insert
  6. Installation and operating instructions manual

Pacific energy Alderlea T5 Classic Insert Installation And Operating Instructions Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
IMPORTANT:
THESE INSTRUCTIONS ARE TO
REMAIN WITH THE HOMEOWNER
SAVE THESE INSTRUCTIONS

SAFETY NOTICE

If this stove is not properly installed, a house
fi re may result. For your safety, follow the
installation instructions.
building or fi re officials about restrictions
and installation inspection requirements in
your area.
TESTED and LISTED
to ULC S628 / UL 1482
Meets the U.S. Environmental Protection
Agency's May 2015 Particulate Emission
Standards
©PACIFIC ENERGY FIRE-
080515-24
PLACE PRODUCTS LTD. - 2014
Contact local
INSTALLATION
AND OPERATING
INSTRUCTIONS
MODEL: ALT5 INSERT
SERIES: D
ALT5.CPINSB
SERIAL #
Alderlea T5
Classic Insert
5055.2031

Advertisement

Table of Contents
loading

Related Manuals for Pacific energy Alderlea T5 Classic Insert

Summary of Contents for Pacific energy Alderlea T5 Classic Insert

  • Page 1: Safety Notice

    INSTRUCTIONS TESTED and LISTED to ULC S628 / UL 1482 Meets the U.S. Environmental Protection Agency's May 2015 Particulate Emission Standards MODEL: ALT5 INSERT SERIES: D ©PACIFIC ENERGY FIRE- 080515-24 ALT5.CPINSB 5055.2031 PLACE PRODUCTS LTD. - 2014...

  • Page 2: Table Of Contents

    Contact local building or fi re officials about restrictions and installation inspection requirements in you area. Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death. ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 3: Safety

    Technical Training when in operation. Keep children, clothing and furniture Training (WETT) CERTIFIED www.wettinc.ca away. Contact may cause skins burns. www.nficertified.org Fig. # 1 Mantel or Top Facing 16" 6.5" 20.5" Fireplace Hearth 2" ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 4: Maintenance Checks

    - The blowers should be cleaned out a minimum every six months by using a vacumn on the blower intakes to remove any dust and debris. See “Fan Speed Controller Relocation” section on page 12, steps 1 & 2, for how to remove the panels and access the blowers. ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.
  • Page 5 Consult CAN/CSA-B365 Installation Code for Solid-Fuel-Burning appliances and equipment in Canada, and N.F.P.A. 211 Standard for chimneys, fi replaces, vents and Solid-Fuel-Burning appliances in USA. MINIMUM EMBER PROTECTION DIMENSIONS 23 1/2” 18” Non-combustible fi replace hearth Non-combustible fl oor covering 2” ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 6: Dimensions

    WITH OVERSIZED SURROUND 34 1/8" 30 3/8" 29 3/8" 33 1/8" 42 1/2" 42 1/2" 17 5/8" 9 1/2" 20 7/8" 21 1/2" 17 5/8" 10 5/8" 23 7/8" 28 3/8" 33 5/8" ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 7: Installation

    The use national building codes. The two methods of fl ue connection of any other offset box may cause a hazard and/ or void that are acceptable in most areas are: any warranty. ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 8: Full Flue Liner (Required In Canada) Fig #2

    Reverse these steps to install casing top. If it is necessary to get access to the connector pipe through the fl ue outlet of the Insert, the baffle can be removed (see Baffle Removal section). ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.
  • Page 9 (Fig. #5 & 6). pressure can cause gases or fumes to be pulled into the liv- ing area. Fig. # 5 Fig. # 7 O/A Cover Screw Remove Knockout ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 10: Surround Assembly And Installation

    Fig. # 11 6) Attach surround to fi rebox by aligning with bracket studs (L) then fasten with washers and nuts (M) on each side. (Fig. #12) Fig. # 12 Fig. # 9 ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 11: Fan Removal/Installation

    3) Remove the two screws securing the fan bracket to the stove using a 7/16” socket or wrench. Reverse steps 1&2 Fig. # 14 to install new fan.(Fig #17) Fig. # 16 Fig. # 17 SCREWS THERMAL SWITCH ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 12: Fan Speed Controller Relocation

    #20).Unscrew thermal snap switch leaving the wires connected(Fig #21). Take note of where the wires are routed and secured. They must be positioned correctly to avoid damage. Fig. # 20 Fig. # 21 SCREWS ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.
  • Page 13 8) Route cable from speed control to fan and reattach wire support tabs on the underside of the ash lip. Note wire positions. (Fig.26 & Fig.27) WIRE SUPPORT TABS Fig. # 26 Fig. # 29 THERMAL SWITCH Fig. # 27 Fig. # 30 ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 14: Operation

    This heater is not designed for open door burning, unless a manufacturer supplied screen is used. ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 15: Restarting After Extended Or Overnight Burns

    3) Inadequate draft may cause backpuffing into the room and Thermo plugging of the chimney. Smoke leaking into the room Switch through appliance and chimney connector joints indicates inadequate draft. ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 16: Electrical Supply

    In summary, a certain amount of creosote is inevitable and must be lived with. Regular inspection and cleaning is the solution. The use of dry, seasoned wood and ample combus- tion air will help to minimize the buildup. ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 17: Maintenance

    Replace clamps and screws. WARNING: Do not overtighten, tighten screws very care- fully. - Do not clean glass when hot - Do not use abrasive cleaners on glass ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 18: Replacement Parts

    ....Crown Assembly, Brown ..ALT5.P50374724BN 6....Ashlip Assy, Black Enamel ..ALT5.P50274723BK ....Crown Assembly, Antique White ...........Ashlip Assy, Majolica Brown Enamel ...... ALT5.P50374724AW ....ALT5.P50374723BN ....Ashlip Assy, Antique White Enamel ........ALT5.P50374723AW NOT SHOWN Fig. # 33 ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 19: Understanding & Operating Your Pacifi C Energy Stove

    5 to particulates (smoke). 10 minutes more and Pacific Energy has then set the air control designed a system that to the desired position.

  • Page 20: Troubleshooting

    - Check outside air supply for obstructions is blocked (see Combustion Air section) 2) Draft too low - Chimney plugged or restricted Inspect and clean - Chimney oversized or otherwise unsuitable Consult Dealer ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 21: Firebrick Installation

    9” X 4 1/2” X 1 1/4” (230 mm x 115 mm x 32 mm) 5096.99 7 1/4” X 4 1/2” X 1 1/4” (184 mm x 115 mm x 32 mm) 245.0 080500-2 WINDBRICK 5055.104 ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 22: Warranty Information

    Pacifi c Energy is not responsible for installation, operational or environmental conditions beyond our control. (The company may, at its discretion, discharge all obligations by refunding the wholesale price of the defective part.) For Warranty claims, please contact your nearest Pacifi c Energy dealer. ©PACIFIC ENERGY FIREPLACE ALT5.CPINSB 080515-24 PRODUCTS LTD.

  • Page 23: Label

    MODEL / MODÈLE: ALT5INS SERIES / SÉRIE: D INSTALL AND USE ONLY IN ACCORDANCE WITH PACIFIC ENERGY’S INSTALLATION AND OPERATING INSTRUCTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT CODES, RESTRICTIONS AND INSTALLATION INSPECTION IN YOUR AREA. INSTALL AND USE ONLY IN MASONRY OR FACTORY BUILT FIREPLACE. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE.
  • Page 24 PACIFIC ENERGY FIREPLACE PRODUCTS LTD. www.pacifi cenergy.net Technical Support: 1-250-748-1184 2975 Allenby Rd., Duncan, B.C. V9L 6V8 Printed in Canada ©PACIFIC ENERGY FIREPLACE PRODUCTS LTD.

Table of Contents