IMPORTANT: THESE INSTRUCTIONS ARE TO REMAIN WITH THE HOMEOWNER SERIAL # SAFETY NOTICE INSTALLATION A N D O P E R AT I N G If this stove is not properly installed, a house fi re may result. For your safety, INSTRUCTIONS follow the installation instructions.
Contents Safety and Maintenance ..................3 Maintenance Checks ................... 4 Creosote ....................... 5 Formation and Need for Removal ..................5 Chimney Fires ........................5 In Case of a Chimney Fire ....................5 Avoiding a Chimney Fire ..................... 5 Assembly ......................6 Crate Removal: ........................
CAUTION: Safety and - do not overtighten, tighten screws very carefully - do not clean glass when hot - do not use abrasive cleaners on glass Maintenance 6. Do not store wood within heater installation clearances, or within the space required for fuel loading and ash removal.
Maintenance Checks Check the following parts for damage such as cracks, excessive corrosion, burned out sections and excessive warping: (See website for descriptions and more detail) Weekly: - Firebrick - Visual, for cracking. - Door Gasket - sagging, placement, damage. Monthly - Brick rail tabs and brick rails.
Creosote In Case of a Chimney Fire 1. Prepare to evacuate to ensure everyone's safety. Have a well understood plan of action for evacuation. Have Formation and Need for Removal a place outside where everyone is to meet. When wood is burned slowly, it produces tar and other 2.
FIG. #1 610mm 510mm 610mm 510mm 403mm 403mm 156mm 145mm 159mm 145mm 705mm 705mm Pacifi c Vista - Pedestal Model Pacifi c Vista - Leg Model 499mm 632mm 403mm 156mm 145mm Vista Classic 705mm Assembly Optional Ash Cleanout System: 1) With stove body laying on its back, remove the ash system hole cover and gasket located under the stove.
Installation Warning: Under no circumstances is this heater to be installed in a make- shift or "temporary" manner. It may be fi red only after the stove is installed properly. DO NOT ATTEMPT TO CONNECT THIS HEATER TO ANY AIR DISTRIBUTION DUCT.
Minimum Clearance to Combustibles FIG. #2 Single Wall Connector 250mm 375mm 527mm 776mm 350mm 660mm 250mm Single Wall Connector with Shield 200mm 527mm 250mm 706mm 350mm 660mm 200mm Floor Protector FIG. #3 Minimum Width - 781mm Minimum Overall Depth - 723mm Minimum Thickness - 6mm The stove may be installed on a combustible fl oor provided ember protection made from a 6mm thick non-combustible material with...
Chimney and Connector WARNING: INSTALL CHIMNEY AND ALL COMPONENTS OF CHIMNEY SYSTEM ACCORDING TO CHIMNEY MANUFACTURER’S INSTRUCTIONS. Connect to a listed chimney complying with the requirements of AS/NZS2918/2001 and a chimney suitable for use with solid fuel that is lined and in good condition and meets local building codes.
Firebrick Installation Instructions Pacifi c Vista and Vista Classic This package contains 12 full-size fi rebricks, as well as 2 various cut-size bricks. If your heater came with an ash cleanout system, or an optional one is being in- stalled, discard one full-size brick. With the heater in the upright position, install fi...
Combustion Air To draw outside air from behind the stove, an outside air adaptor may be required cut or drill a 100mm hole through a wall behind the unit. Use an appropriate Intake or combustion air can be supplied to the stove household 100mm inlet.
3. Ignite the paper and close the door. 4. After the fi re has established itself, open the door and Your PACIFIC ENERGY heater is designed for maximum overall add a few small logs. Close door. efficiency at a moderate fi ring rate. Overfi ring is hazardous and 5.
WARNING: Always keep loading door closed when Disposal of Ashes burning. This heater is not designed for open door burning. Ashes should be placed in a metal container with a tight fi tting lid. The closed container of ashes should be placed WARNING: No alteration or modifi cation of the com- on a non-combustible fl oor or on the ground, well away bustion air control assembly is permitted.
Appendix A Troubleshooting PROBLEM CAUSE CURE GLASS IS DIRTY 1. Wood is wet - Use dry wood 2. Turning down air control - Do not turn down until: too soon a) there is a good bed of coals b) the wood is charred 3.
Replacement Parts - Pacifi c Vista FIGURE #5 (WHEN ORDERING, INCLUDE PART NUMBER WITH DESCRIPTION) ITEM DESCRIPTION PART NO. ITEM DESCRIPTION PART NO. 1..Side shield, left or right ..... VIST.2201 18 ..Pedestal ........ VIST.2205WELD 2..Top defl ector ........VIST.2229 19 ..Ash drawer enclosure ....... VIST.2219 3..Ashlip (c/w hardware) ....
Replacement Parts - Vista Classic FIGURE #6 (WHEN ORDERING, INCLUDE PART NUMBER WITH DESCRIPTION) ITEM DESCRIPTION PART NO. ITEM DESCRIPTION PART NO. 1..Vista Classic side shield, L/R .... VISC.2251 19 ..Ash drawer enclosure ......VIST.2219 2..Vista Classic top ........ VISC.2240 0..Leg, Black ........CAST.LEGST 3..
Understanding & Operating Your Pacifi c Energy Stove The Pacifi c Energy SUPER SERIES line of OPERATING TIPS woodstoves is a culmination of years of research and development. Designed to be efficient, 1. Always use dry, seasoned fi rewood, up to clean-burning and user-friendly, this heater will 457mmlong.