Maintenance Checks; Weekly; Monthly; When Cleaning The Chimney System - Pacific energy ALDERLEA T6 LE Operating And Installation Instructions

Check the following parts for damage such as cracks, excessive corrosion, burned out sections and
excessive warping: (See website for descriptions and more detail)

Weekly:

• Firebrick - Visual, for cracking.
• Door Gasket - sagging, placement, damage.

Monthly

• Brick rail tabs and brick rails.
• Air riser tube in the back of the firebox.
• Back side of airwash chamber.
• Baffle locking pin.
• Boost tube cover.

When Cleaning the Chimney System:

• Top baffle board/blanket.
•

Baffle.

• Top heat shield and mounting bolt.
• Baffle Gasket.
• Brick Rails.
• Manifold.

Blower:

• The blower should be cleaned out a minimum every six months by using a vacumn on the grill openings in
the back and bottom of the blower casing to remove any dust and debris.
Baffle:
• Some warping of the baffle is normal(up to 1/4" or .65cm). Replace if the baffle has permanent warping
greater than this or has cracking or breakage.
• Please contact your Dealer if you experience any of the damage listed above. Continuing to operate your
stove with broken parts may accelerate damage to other parts and may void your warranty
Chimney connector pipe should be disconnected from stove to clean and inspect. Only if this is not possible
should you remove baffle assembly.
DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.
Removal:
Remove retaining pin at the back top of the firebox, just under the baffle. Lift baffle up and pull forward to
disconnect from the supply tube. Tilt baffle sideways to drop down and remove from firebox. Inspect gasket
between baffle and supply tube. If necessary, replace with gasket #139.5 available from your Pacific Energy
dealer. Re-install baffle assembly in reverse order. The two side pieces of insulation must be tight against the
side rails.
100000087

Maintenance Checks

Baffle Removal

10
ALDERLEA T6-LE_260319-28