Installation - Mobile Home; Clearances - Mobile Home; Minimum Clearances To Combustibles - Mobile Home - Pacific energy ALDERLEA T6 Installation & Operation Manual

Installation – Mobile Home
Warning:
Under no circumstances is this heater to be installed in a makeshift or "temporary" manner.
It may be fired only after the following conditions have been met.
• DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER
APPLIANCE.
• DO NOT INSTALL IN A SLEEPING ROOM.
Outside air supply must be used for Mobile Home installations (see Figure #4, Page 10).
We recommend that our woodburning hearth products be installed and serviced by
professionals who are certified in the U.S. by the National Fireplace Institute
NFI woodburning Specialists or who are certified in Canada by Wood Energy Technical
Training (WETT).
BOTH CHIMNEY SYSTEM AND CONNECTOR MUST BE LISTED TO: IN CANADA
- ULC S-641 LISTED CONNECTOR AND ULC-S-629 LISTED CHIMNEY, IN USA
- UL-103 HT LISTED CONNECTOR AND CHIMNEY
Clearances – Mobile Home
This heater must be installed with listed double-wall connector and compatible chimney
system listed on page 10.
Clearances to combustible surfaces and materials are shown below in Figures #3.
Clearances may be reduced with various heat insulating materials. Consult local, National
fire codes and authorities for approval.
NOTE: Longer chimney lengths and different pitch flashings may be used. All other parts
listed must be installed (see Page 10). Install all components to the connector or chimney
manufacturer's installation requirements. Consult your chimney supplier for installation
advice.
Fig #3
Minimum Clearances to Combustibles – Mobile Home
10"
254mm
18.75"
476mm
190617-24 AL6B
DOUBLE WALL CONNECTOR
18"
457mm
32.75"
832mm
CAUTION:
The structural integrity of the mobile
home floor, wall, and ceiling/roof
must be maintained.
(NFI) as
®
203mm
©PACIFIC ENERGY FIREPLACE
9
PRODUCTS LTD.
8"
22.25"
203mm
565mm
8"