Pacific energy SUPER 27 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Pacific energy Manuals
  4. Wood stove
  5. SUPER 27 SPECTRUM
  6. Operating instructions manual

Pacific energy SUPER 27 Operating Instructions Manual

Hide thumbs Also See for SUPER 27:
Table of Contents

Advertisement

Quick Links

See also: Operation & Installation Manual
IMPORTANT:
THESE INSTRUCTIONS ARE TO
REMAIN WITH THE HOMEOWNER

SAFETY NOTICE

If this stove is not properly installed, a
house fi re may result. For your safety,
follow the installation instructions. Contact
local building or fire officials about
restrictions and installation inspection
requirements in your area.
230514-20
INSTALLATION
A N D O P E R AT I N G
INSTRUCTIONS
MODEL - SUPER 27
SPECTRUM
SPECTRUM CLASSIC
DESIGN-D
SUPER-SD1
SERIAL #
5055.201AS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SUPER 27 and is the answer not in the manual?

Questions and answers

Related Manuals for Pacific energy SUPER 27

Summary of Contents for Pacific energy SUPER 27

  • Page 1: Safety Notice

    If this stove is not properly installed, a house fi re may result. For your safety, follow the installation instructions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. MODEL - SUPER 27 SPECTRUM SPECTRUM CLASSIC DESIGN-D 230514-20 SUPER-SD1...

  • Page 2: Table Of Contents

    Baffle Removal ....................13 Appendix A ......................14 Troubleshooting ........................ 14 Replacement Parts - Super 27 ..................15 Replacement Parts - Spectrum and Spectrum Classic ............ 16 Understanding & Operating Your Pacifi c Energy Stove ............. 17 Compliance Plate......................19 PLEASE SAVE THESE INSTRUCTIONS NOTE: WE STRONGLY RECOMMEND THAT SMOKE DETECTORS BE INSTALLED.

  • Page 3: Safety And Maintenance

    Safety and CAUTION: - do not overtighten, tighten screws very carefully - do not clean glass when hot Maintenance - do not use abrasive cleaners on glass 6. Do not store wood within heater installation clearances, 1. Burn wood only, dry and well seasoned. The denser or or within the space required for fuel loading and ash heavier the wood when dry, the greater its heat value.

  • Page 4: Maintenance Checks

    Maintenance Checks Check the following parts for damage such as cracks, excessive corrosion, burned out sections and excessive warping: (See website for descriptions and more detail) Weekly: - Firebrick - Visual, for cracking. - Door Gasket - sagging, placement, damage. Monthly - Brick rail tabs and brick rails.

  • Page 5: Creosote

    Creosote In Case of a Chimney Fire 1. Prepare to evacuate to ensure everyone's safety. Have Formation and Need for Removal a well understood plan of action for evacuation. Have a place outside where everyone is to meet. When wood is burned slowly, it produces tar and other organic vapours, which combine with expelled moisture 2.

  • Page 6: Assembly

    FIG. #1 Super 27 - Pedestal Model Spectrum 711mm 699mm 610mm 600mm 600mm 606mm 254mm 254mm 740mm 740mm 721mm 702mm Super 27 - Leg Model Spectrum Classic 699mm 711mm 606mm 610mm 600mm 600mm 254mm 254mm 737mm 737mm 699mm 718mm Assembly...

  • Page 7: Installation

    Installation Warning: Under no circumstances is this heater to be installed in a make- shift or "temporary" manner. It may be fi red only after the stove is installed properly. DO NOT ATTEMPT TO CONNECT THIS HEATER TO ANY AIR DISTRIBUTION DUCT.

  • Page 8: Floor Protector

    Minimum Clearance to Combustibles FIG. #2 Single Wall Connector 559mm 350mm 275mm 893mm 375mm 762mm 275mm Single Wall Connector with Shield 200mm 100mm 559mm 375mm 787mm 762mm 200mm Floor Protector FIG. #3 Minimum Width - 826mm Minimum Overall Depth - 923mm The stove may be installed on a combustible fl oor provided ember Minimum Thickness - 6mm protection made from a 6mm thick non-combustible material with...

  • Page 9: Chimney And Connector

    Chimney and Connector WARNING: INSTALL CHIMNEY AND ALL COMPONENTS OF CHIMNEY SYSTEM ACCORDING TO CHIMNEY MANUFACTURER’S INSTRUCTIONS. Connect to a listed chimney complying with the requirements of AS/NZS2918/2001 and a chimney suitable for use with solid fuel that is lined and in good condition and meets local building codes.

  • Page 10: Firebrick Installation Instructions

    Firebrick Installation Instructions Super 27, Spectrum, Spectrum Classic, and Fusion This package contains 18 full-size fi rebricks, as well as 3 various cut-size bricks. If your heater came with an ash cleanout system, or an optional one is being installed, discard the extra full brick.

  • Page 11: Combustion Air

    Combustion Air To draw outside air from behind the stove cut or drill a 100mm hole through a wall behind the unit. Use an appropriate household 100mm inlet. You must remove the rear cover plate from the pedestal or move the Intake or combustion air can be supplied to the stove cover plate at the rear of the leg kit ash box enclosure in one of two ways.

  • Page 12: Operation

    3. Ignite the paper and close the door. 4. After the fi re has established itself, open the door and Your PACIFIC ENERGY heater is designed for maximum overall add a few small logs. Close door. 5. Begin normal operation after a good coal base exists efficiency at a moderate fi ring rate.

  • Page 13: Restarting After Extended Burns

    WARNING: Always keep loading door closed when Disposal of Ashes burning. This heater is not designed for open door burning. Ashes should be placed in a metal container with a tight fi tting lid. The closed container of ashes should be placed WARNING: No alteration or modifi cation of the com- on a non-combustible fl oor or on the ground, well away bustion air control assembly is permitted.

  • Page 14: Troubleshooting

    Appendix A Troubleshooting Problem Cause Cure Glass is Dirty 1. Wood is wet - Use dry wood 2. Turning down air control - Do not turn down until or damper too soon a) there is a good bed of coals b) the wood is charred 3.

  • Page 15: Replacement Parts - Super 27

    Replacement Parts - Super 27 (WHEN ORDERING, INCLUDE PART NUMBER WITH DESCRIPTION) ITEM DESCRIPTION PART NO. ITEM DESCRIPTION PART NO. 1.... Side Shield, Left or Right....SUPD.4302 20..Ash System (Leg Model) ....SUPD.LGADA 2.... Rear Defl ector ........SSER.229 21..

  • Page 16: Replacement Parts - Spectrum And Spectrum Classic

    Replacement Parts - Spectrum and Spectrum Classic (WHEN ORDERING, INCLUDE PART NUMBER WITH DESCRIPTION) ITEM DESCRIPTION PART NO. ITEM DESCRIPTION PART NO. 1.... Side Shield, Left or Right..... SPED.4403_ _B 20..Ash Box (Spectrum) ......WODC.4316 2.... Rear Defl ector ........SPEC.4418 21..

  • Page 17: Understanding & Operating Your Pacifi C Energy Stove

    Understanding & Operating Your Pacifi c Energy Stove The Pacifi c Energy SUPER SERIES line of OPERATING TIPS woodstoves is a culmination of years of research and development. Designed to be efficient, 1. Always use dry, seasoned fi rewood, up to clean-burning and user-friendly, this heater will 457mm long.
  • Page 18 SUPER-SD1 230514-20...

  • Page 19: Compliance Plate

    Compliance Plate PACIFIC ENERGY FIREPLACE PRODUCTS LTD. 2975 ALLENBY RD., DUNCAN, BC V9L 6V8 Model: ALDERLEA T5, SUPER 27, SPECTRUM, SPECTRUM CLASSIC, FUSION, STED D1 Series: D Type: FREESTANDING Tested by: HRL TECHNOLOGY PTY LTD TRAMWAY ROAD, MORWELL, VICTORIA Tested to: AS/NZS 4013:1999...
  • Page 20 PACIFIC ENERGY FIREPLACE PRODUCTS LTD. 2975 Allenby Rd., Duncan, B.C. V9L 6V8 Phone: 250-748-1184 Web site: http://www.pacifi cenergy.net Printed in Canada...

This manual is also suitable for:

Spectrum classicSpectrumDesign-d

Table of Contents