Pacific energy VISTA Installation And Operating Instructions Manual

Pacific energy VISTA Installation And Operating Instructions Manual

Series - c

Advertisement

IMPORTANT:
THESE INSTRUCTIONS ARE TO
REMAIN WITH THE HOMEOWNER

SAFETY NOTICE

If this stove is not properly installed, a
house fi re may result. For your safety,
follow the installation instructions. Contact
local building or fire officials about
restrictions and installation inspection
requirements in your area.
TESTED and LISTED to CAN/ULC S627
and UL 1482
Meets the Environmental Protection
Agency's July 1990 Particulate
Emission Standards
201213 -20
INSTALLATION
A N D O P E R AT I N G
INSTRUCTIONS
Models
Pacifi c VISTA
VISTA CLASSIC
SERIES - C
VISTA and CLASSIC-C
SERIAL #
5055.3

Advertisement

Table of Contents
loading

Summary of Contents for Pacific energy VISTA

  • Page 1: Safety Notice

    TESTED and LISTED to CAN/ULC S627 and UL 1482 Meets the Environmental Protection Agency’s July 1990 Particulate Emission Standards Models Pacifi c VISTA VISTA CLASSIC SERIES - C 201213 -20 VISTA and CLASSIC-C 5055.3...
  • Page 2: Table Of Contents

    Optional Outside Air Adaptor .................... 13 Appendix A ......................14 Troubleshooting ........................ 14 Replacement Parts - Pacifi c Vista ..................15 Replacement Parts - Vista Classic..................16 Understanding & Operating Your Pacifi c Energy Stove ............. 17 Firebrick Installation Instructions ..................18 Label ..........................
  • Page 3: Safety And Maintenance

    CAUTION: Safety and - do not overtighten, tighten screws very carefully - do not clean glass when hot - do not use abrasive cleaners on glass Maintenance 6. Do not store wood within heater installation clearances, or within the space required for fuel loading and ash removal.
  • Page 4: Maintenance Checks

    Maintenance Checks Check the following parts for damage such as cracks, excessive corrosion, burned out sections and excessive warping: (See website for descriptions and more detail) Weekly: - Firebrick - Visual, for cracking. - Door Gasket - sagging, placement, damage. Monthly - Brick rail tabs and brick rails.
  • Page 5: Creosote

    Creosote In Case of a Chimney Fire 1. Prepare to evacuate to ensure everyone's safety. Have a well understood plan of action for evacuation. Have Formation and Need for Removal a place outside where everyone is to meet. When wood is burned slowly, it produces tar and other 2.
  • Page 6: Assembly

    15 7/8" 15 7/8" 6 1/4" 5 11/16" 6 1/4" 5 11/16" 27 3/4" 27 3/4" Pacifi c Vista - Pedestal Model Pacifi c Vista - Leg Model 24 7/8" 19 5/8" 15 7/8" 5 11/16" 6 1/4" Vista Classic 27 3/4"...
  • Page 7 Spark arrestor FIG. #2 rain cap Chimney 36" (914 mm) Storm collar Minimum The chimney may incorporate Roof fl ashing an offset. To do this safely, all sections of listed connector, offset Radiation shield elbows and chimney section must be screwed together by at least three sheet metal screws per joint.
  • Page 8: Mobile Home Installation

    Pacifi c Vista and Vista Classic: Clearances to com- this point. (Seal securely) Attach rain cap and check bustible surfaces and materials are shown in Figure fl ashing for leaks.
  • Page 9: Residential

    1. This heater may be installed using a single-wall connec- tor (smoke pipe) or a listed double-wall connector. Pacifi c Vista and Vista Classic: Clearances to combus- tible surfaces and materials are shown in Figure #1a, page 4.
  • Page 10: Floor Protector

    Combustion Air Floor Protector Intake or combustion air can be supplied to the stove The stove may be installed on a combustible fl oor provided in one of two ways. Consult your local building code or non-combustible protection is used. CAN/CSA-B365, Installation Code for Solid-Fuel-Burning This protection must extend as follows: Appliances and Equipment before proceeding.
  • Page 11: Operation

    Over Firing and wood has charred. Normal Operation Your PACIFIC ENERGY heater is designed for many years of trouble free operation. Over fi ring the appliance 1. Set air control to a desired setting. If smoke pours will shorten the life of the product. Failure to recitify an...
  • Page 12: Restarting After Extended Or Overnight Burns

    Restarting After Extended Burns Baffle 1. Open door and rake hot embers towards the front of Removal the heater. Add a couple of dry, split logs on top of embers, close door. 2. Adjust air control to "H" (high) and in just a few minutes, logs should begin burning.
  • Page 13: Optional Blower

    Optional Optional Outside Air Adaptor The adaptor is only required if the blower kit is to be in- Blower stalled and outside combustion air to be ducted to rear of pedestal. Installation: The optional blower kit (# WODC.BLOW) is equipped with a three prong power cord and may be installed at any time.
  • Page 14: Troubleshooting

    Appendix A Troubleshooting PROBLEM CAUSE CURE GLASS IS DIRTY 1. Wood is wet - Use dry wood 2. Turning down air control - Do not turn down until: too soon a) there is a good bed of coals b) the wood is charred 3.
  • Page 15: Replacement Parts - Pacifi C Vista

    Replacement Parts - Pacifi c Vista FIGURE #4a (WHEN ORDERING, INCLUDE PART NUMBER WITH DESCRIPTION) ITEM DESCRIPTION PART NO. ITEM DESCRIPTION PART NO. 1..Side shield, left or right ..... VIST.2201 18 ..Pedestal ........ VIST.2205WELD 2..Top defl ector ........VIST.2229 19 ..Ash drawer enclosure ....... VIST.2219 3..Ashlip (c/w hardware) ....
  • Page 16: Replacement Parts - Vista Classic

    ITEM DESCRIPTION PART NO. ITEM DESCRIPTION PART NO. 1..Vista Classic side shield, L/R .... VISC.2251 19 ..Ash drawer enclosure ......VIST.2219 2..Vista Classic top ........ VISC.2240 0..Leg, Black ........CAST.LEGST 3..Vista Classic ashlip ......ALIP.2264xx ...Leg, Gold ........CAST.LEGGLD 4..Door catch ........
  • Page 17: Understanding & Operating Your Pacifi C Energy Stove

    Understanding & Operating Your Pacifi c Energy Stove The Pacifi c Energy SUPER SERIES line of OPERATING TIPS woodstoves is a culmination of years of research and development. Designed to be efficient, 1. Always use dry, seasoned fi rewood, up to 18" clean-burning and user-friendly, this heater will long.
  • Page 18: Firebrick Installation Instructions

    Firebrick Installation Instructions Pacifi c Vista and Vista Classic This package contains 12 full-size fi rebricks, as well as 2 various cut-size bricks. If your heater came with an ash cleanout system, or an optional one is being in- stalled, discard one full-size brick.
  • Page 19: Label

    Label MUR COTE MUR ADJACENT SIDE WALL ADJACENT WALL COTE SIDE 201213-20...
  • Page 20 PACIFIC ENERGY FIREPLACE PRODUCTS LTD. 2975 Allenby Rd., Duncan, BC V9L 6V8 Phone: 250-748-1184 Web site: www.pacifi cenergy.net Printed in Canada 201213-20...

This manual is also suitable for:

Vista classic

Table of Contents