Connectors And Blocks - Digi Connect Wi ME 9210 Hardware Reference Manual

Connectors and Blocks

The development board provides the following connectors and blocks:






See the figure titled "Board Layout and Connector Locations:" on page 15 for the location of the
connectors and blocks. The following sections describe the connectors and blocks.
Embedded Module Connector, P10
The Digi Connect ME embedded module Connector is a 20-pin female vertical header that is
labeled P10 on the development board. See the following figure for pin orientation; see the
following table for pin assignments.
Note:
Embedded Module Connector, P10
The Digi Connect Wi-ME module does not provide pins 1-6
JTAG Debugger Connector, P12.
-48V DC input to PoE module (Digi Connect ME 9210 must be connected to a
Powering Device for this feature.), P13
12V DC output from PoE module into Dev Board Power Supply, P14
Logic Analyzer Header, P3
The figure shows the connector using the same orientation as shown in the figure titled
"Board Layout and Connector Locations:" on page 15.
2 0
      