Connectors: Antenna - Digi Connect Wi ME 9210 Hardware Reference Manual

Hard Reset
The embedded modules support a hardware reset on pin 8 of the 14-pin header. Pulling pin 8 low
with an open drain driver will force the module into a hard reset state. The module will remain in the
reset state as long and pin 8 is held low and will leave this reset state ~250mS after pin 8 goes high.
Do not actively drive pin 8 high and do not allow the rise time of the pin 14 to be longer than 100uS.
When used with the development board, this pin is wired to reset button SW4, which means it acts
as a hard reset button.

Connectors: Antenna

The Digi Connect Wi-ME 9210 and Digi Connect ME 9210 is available with 1 RP-SMA connector.
The antenna is connected to the module with a reverse polarity SMA connector (sub-miniature size
A). The antenna only fits on the module one way to ensure a proper connection.
Jumper is in
the 1/2 position
Caution: This Part 15 radio device operates on a non-interference basis
with other devices operating at this frequency when using the antennae
listed in the Antenna Specification table. Any changes or modification to
the product not expressly approved by Digi International could void the
user's authority to operate the device.
Part number
Antenna Specifications
Type Dipole
DG-ANT-20DP-BG
Gain 2 dBi
1 2
      