Reset
Hard Reset
The Digi Connect Wi-ME 9210 module supports a hardware reset via pin 8 of the 14-pin header.
The unit is forced into a hard reset when pulling the pin to ground, or less than 0.8v, for one
microsecond. When plugged into a development board, this pin is wired to the push button at SW4.
As a result, this switch acts as a hard reset button.
Reset Characteristics
Characteristic
Specification
Delay
250 milliseconds (typical)
Low ActiveThreshold
0.8 V
High Inactive Threshold
2.4V
Minimum Hold Time
1 microsecond pulse
Rise Time
100 microseconds max
3 3