Assembly - Grizzly G0866 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Assembly of the Model G0866 consists of install-
ing the air line and the sanding belt, and verifying
the factory-set pressure roller settings.
To assemble machine:
1.
Connect compressed air line to air inlet on
regulator (see Figure
hose clamp.
Regulator
Knob
Figure 31. Air regulator inlet and ON/OFF
handle.
2. Start air compressor or open air valve at
compressor.
3. Make sure red ON/OFF handle on regulator
position (see Figure 31).
is in open
-24-
31) and secure with
Air ON/OFF
Handle
(Open Position)
Air Inlet
4. Lift regulator knob to unlock it (see Figure
32) and rotate it until gauge reads 75 PSI.
Note: Rotate knob clockwise to increase air
pressure and counterclockwise to decrease.
Decrease
Increase
Lock
Figure 32. Regulator knob.
5.
Push knob down until it snaps to lock knob.
6.
With machine connected to air, open left door
and turn belt tension knob to detensioned
position (see Figure 33).
7.
Remove lock post release lever by turning it
counterclockwise a
and out of mounting hole (see Figure 33).
8. Remove spacer block (see Figure 33).
Lock Post
Release
Lever
Figure 33. Components used when installing a
sanding belt.
Model G0866 (Mfd. Since 11/18)
Unlock
⁄ turn and pulling it up
1
2
Belt Tension
Knob
(Detensioned)
Spacer Block