Grizzly G0866 Owner's Manual page 32

— If table moves in same direction as but-
ton description, power supply polarity is
correct.
— If table moves in opposite direction to
arrow on button, stop machine and
DISCONNECT FROM POWER. Phase
polarity of incoming power is reversed.
Refer to Correcting Phase Polarity on
Page 28 before proceeding with remain-
der of Test Run.
You MUST verify that table moves in expect-
ed direction according to buttons pressed
on control panel, otherwise all controls will
function in reverse. Conveyer belt and sand-
ing belts MUST rotate in the correct direc-
tion or serious personal injury could occur.
7. Press front sanding belt start button to turn
front main motor ON (see Figure 46). Verify
motor starts up and runs smoothly without
any unusual problems or noises.
Front Sanding Belt
Start Button
Rear Sanding Belt
Start Button
Figure 46. Control panel controls.
8.
Press Emergency Stop button to turn machine
OFF.
9.
WITHOUT resetting Emergency Stop button,
try to start machine by pressing front sand-
ing belt start button. The machine should not
start.
— If the machine does not start, the safety
feature of the Emergency Stop button is
working correctly. Proceed to next step.
-30-
Conveyer Belt
Start Button
— If the machine does start, immediately
turn it OFF and disconnect power. The
safety feature of the Emergency Stop but-
ton is NOT working properly and must be
replaced before further using the machine.
10. Repeat Steps 7–9 with the rear sanding belt
start button and then the conveyor belt start
button to test rear main motor and feed motor
(see Figure 46). Both should run smoothly
and without unusual problems or noises. Belt
should move away from operator and toward
sanding drums while feed motor is running.
11. Reset Emergency Stop button.
12. Press sanding belt and conveyor belt start
buttons, then press EMERGENCY STOP!
plate (see Figure 47).
EMERGENCY STOP!
Plate
Figure 47. EMERGENCY STOP! plate location.
— If sanding belts and conveyer belt do not
come to a complete stop, immediately dis-
connect power. The safety feature of the
EMERGENCY STOP! plate is NOT work-
ing properly. This must be fixed before
machine can be used further.
— If sanding belts and conveyer belt do come
to a complete stop, the safety feature of
the EMERGENCY STOP! plate is working
correctly. Congratulations! The Test Run
is complete.
Model G0866 (Mfd. Since 11/18)