Adjusting Conveyor Belt Tension - Grizzly G0866 Owner's Manual

11. Remove (8) hex bolts and flat washers secur-
ing bearing housing in place (see Figures
110–111).
Bearing Housing
Figure 110. Location of top bearing housing hex
bolts and washers.
Figure 111. Location of bottom bearing housing
hex bolts and washers.
12. Remove bearing housing to access right rub-
ber roller pulley and remove old V-belt.
13. Place new set of V-belts onto rubber roller
pulleys and then loop other end of V-belts
around motor pulleys (see Figure 112).
Figure 112. Location of drum and motor pulleys.
-62-
x 4
x 4
Rubber Roller
Pulleys
Motor Pulleys
14. Install eccentric tube and tighten cap screws
to secure.
15. Install bearing housing and secure with hex
bolts and washers removed in Step 11.
16. Install square frame end and securing Phillips
head screws, then replace cap screws
removed in Step 9.
17. Remove wood blocks supporting rollers.
18. Properly tension V-belts (refer to Checking/
Adjusting V-Belt Tension on Page 59 for
more information).
19. Close and secure right access panels.
Adjusting Conveyor
Belt Tension
The conveyor belt tension has been adjusted at
the factory and should require no further atten-
tion. However, adjust the conveyor belt tension if
you notice that your conveyor belt is slipping or is
tracking off center.
The conveyor belt tension is adjusted by rotating
two adjustment bolts, located on each side of the
conveyor table (see Figure 113).
Figure 113. Location of conveyor belt adjust-
ment bolts (1 of 2 shown).
Tool Needed:
Open-End Wrench 19mm ...................................1
Model G0866 (Mfd. Since 11/18)
Conveyor
Belt
Adjustment
Bolt
(1 of 2
Shown)
Qty