Grizzly G0866 Owner's Manual page 27

Directional arrows on back of sanding belt
must be pointing in a counterclockwise
direction during installation. Failure to
install sanding belt correctly will result in
damage to sanding belt.
9. Install sanding belt on upper roller and lower
roller, starting with upper, making sure rota-
tion arrows on sanding belt point in same
direction as those shown in Figure 34.
Note: Sanding belt must be centered between
limit switch tips, and edge of sanding belt
must be between tongs of belt oscillation
controller fork, as shown in Figures 34–35.
Damage to sanding belt and sander may
occur if sander is tensioned and turned ON
before sanding belt is correctly positioned.
Belt Centered
in Fork
Figure 34. Sanding belt placement components.
Model G0866 (Mfd. Since 11/18)
(Back)
10. Replace spacer block and lock post release
11.
12.
Pressure rollers must be set below level of
Limit Switch sanding roller. If pressure rollers are even,
Tip or higher than sanding roller, wood WILL
be propelled from machine at high rate of
speed toward front of machine. This could
cause serious kickback injury.
13. Joint 42" 2x4 so one side is flat, then use flat
Oscillation Controller Fork
Sanding Belt
Limit Switch Tips
Figure 35. Sander outline (top view) of proper
position of belt.
lever.
With hands clear of all moving parts, turn belt
tension knob to 12 o'clock position to tension
belt.
Repeat Steps 6–11 with second sanding belt
and drum.
side against table saw fence to cut opposite
side of workpiece parallel.
IMPORTANT: 2x4 MUST have uniform thick-
ness for following steps to be completed
correctly.
(Front)
-25-