Grizzly G0866 Owner's Manual page 56

11. Remove (1) flat head screw, brake mount-
ing plate, compression spring, bushing, and
outer brake pad (see Figure 91).
Outer
Brake
Pad
x 1
Figure 91. Location of brake mounting plate,
mounting screw, and outer brake pad.
Note: Be careful when removing these com-
ponents. They are under pressure from the
compression spring (see Figure 92), and
could fly apart unexpectedly.
Compression
Spring
Figure 92. Location of compression spring and
bushing.
12. Install new outer brake pad then secure with
bushing, spring, mounting plate, and flat
head screw. Make sure to re-install compo-
nents in same order and orientation as they
were removed (see Figure 93).
-54-
Brake
Mounting
Plate
Figure 93. Order of assembly for outer brake
13. Install gasket, front brake guard, screws and
14. Install lock washer and hex nut removed in
15. Install disc brake assembly around rotor on
16. Connect air line removed in Step 6 and
17. Replace brake pads on second brake assem-
Bushing
18. Close lower right access door.
19. Connect air supply to air regulator and
Note: The countersunk end of the bushing
faces the diaphragm plate (see Figure 93).
pad components.
stud removed in Steps 9–10.
Step 9.
motor base using (2) mounting bolts and
washers removed in Step 4.
secure with lock nut.
bly in same manner as the first.
machine to power and start sander to test
Emergency Stop system to make sure brake
works.
Model G0866 (Mfd. Since 11/18)
Diaphragm
Plate