Grizzly G0866 Owner's Manual page 55

4. Remove (2) mounting bolts, lock washers,
and flat washers that secure disc brake
assembly to machine motor plate (see
85), then pull disc brake assembly away from
rotor.
Figure 85. Location of disc brake assembly
mounting fasteners.
5.
Measure thickness of each brake pad. The
brake pads consist of a metal plate with a
composite pad. Measure thickness of com-
posite pads only (see
— If thickness of both pads is greater than
(see Figure 86), pads do not need to be
replaced. Proceed to Step 15.
— If thickness of either pad is less than
Figure 86), proceed to Step 5 to replace
both pads.
6. Loosen lock nut and remove air line connec-
tion (see Figure 86).
Min / "
1
8
Thickness
For Each
Brake
Assembly
Figure 86. Brake pad measurement.
Note: Rear motor brake assembly has two air
connections to disconnect.
Model G0866 (Mfd. Since 11/18)
Figure
Mounting
Fasteners
(1 of 2)
Figure 86).
⁄ "
1
8
⁄ " (see
1
8
Air Line
Lock Nut
7. Remove (1) cap screw, then remove inner
brake pad (see Figure
x 1
Figure 88. Location of inner brake pad and
mounting cap screw.
8. Install new inner brake pad and replace cap
screw.
9. Remove (1) brake mount stud by removing
lock washer and hex nut (see Figure 89).
Hex Nuts &
Lock Washers
Figure 89. Location of brake mount studs and
fasteners.
10. Remove (8) cap screws, front brake guard,
and gasket (see Figures 90).
Front
Brake Guard
Figure 90. Location of front brake guard, cap
screws, and gasket.
88).
Inner
Brake Pad
Studs
x 8
Hidden Gasket
-53-