Table of Contents
Advertisement
Mounting
Number of Mounting Holes ............................ 4
Diameter of Mounting Hardware Needed .
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Figure 4. Example of a "Through Mount" setup.
Another option is a "Direct Mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Machine Base
Workbench
Figure 5. Example of a "Direct Mount" setup.
-14-
⁄
"
5
16
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Lag Screw
Flat Washer
Assembly
Place the lock knob, table inserts, sanding drums
and sleeves, and drum washers in their desig-
nated accessory slots beneath the table (see
Figure 6).
Figure 6. G0723 fully assembled.
Dust Collection
DO NOT operate the Model G0723 without an
adequate dust collection system. This sand-
er creates substantial amounts of wood dust
while operating. Failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Model G0723 (Mfd. Since 03/24)
Advertisement
Table of Contents
