Emptying Dust And Water Traps - Grizzly G0866 Owner's Manual

Feed Belt Gearbox
Oil Type .................... T28042 or ISO-VG 320 Oil
Oil Amount ......................................... As Needed
Frequency .... After first 300 hrs., every 2500 hrs.
Items Needed
Drain Pan ........................................................... 1
Wrench 14mm ................................................... 1
If gearbox oil is low, remove fill plug (see Figure 68)
and all new oil until sight glass is full, then re-
install fill plug.
If gearbox oil needs to be changed, run machine
to warm gearbox before removing fill plug and
drain plug (see Figure 68), draining oil, then re-
installing drain plug. Add new oil until sight glass
is full, then re-install fill plug.
Fill Plug
Drain Plug
Figure 68. Gearbox lubrication components.
Model G0866 (Mfd. Since 11/18)
Qty
Sight Glass
Emptying Dust and
Water Traps
Three collection traps on this sander need to be
emptied regularly. DO NOT allow any of these
traps to become full or you risk serious damage
to your machine.
The air pressure regulator water trap (see Figure
69) is attached to the air pressure regulator and
traps condensation in the incoming air supply.
With the system under air pressure, push the
lower drain valve and empty the regulator water
trap (see Figure 69). Replace the internal white
moisture filters annually.
Drain Valve
Figure 69. Location of regulator water trap and
drain valve.
There are two dust trap bowls inside the upper
right access panel (see Figure 70). To empty
these, turn air pressure OFF, allow pressure to
bleed out, then unscrew and empty bowls.
Dust Trap Bowl
(1 of 2)
Figure 70. Location of dust cups.
Regulator
Water Trap
-43-