Lifting & Placing - Grizzly G0866 Owner's Manual

Lifting & Placing
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
Do not attempt to lift or move this machine without
using the proper lifting equipment (such as forklift
or crane). Each piece of lifting equipment must
be rated for at least 5000 lbs. to support dynamic
loads that may be applied while lifting. Refer to
Needed for Setup on Page 18 for complete list
of needed equipment for setup and installation.
To lift and move machine:
1.
Remove shipping crate top and sides, then
remove small components from shipping
pallet.
2.
Move machine to its prepared location while
it is still attached to shipping pallet.
-22-
HEAVY LIFT!
3. Open lower access panels and remove (4)
lag screws and flat washers that secure
machine to pallet (see Figure 27), then close
panels.
Note: The holes these fasteners are removed
from will later be used to anchor machine to
floor.
Figure 27. Mounting hardware and leveling bolts
(right side shown).
4. Carefully place forklift forks under sander
(see Figure 28).
Figure 28. Example of lifting machine with forklift
example.
5.
Lift sander off pallet, remove pallet, then
slowly lower sander into position.
Model G0866 (Mfd. Since 11/18)
x 4
Forklift Fork