Disarming The System - Subaru 2004 Legacy Owner's Manual

To arm the system using power door locking
switches
1. Close all windows and moonroofs (if so equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid)
is locked.
5. Close the doors (and the rear gate on the station
wagon) but leave only the driver's door or the front
passenger's door open.
7
6. Push the power door locking switch forward
("LOCK" side) to set the door locks.
7. Close the door. An electronic chirp will sound one
time, the turn signal lights will flash one time and the
indicator light will start flashing slowly (approximately
once every two seconds) to inform you that the system
has armed.
NOTE
The system can be armed even if the engine hood,
the windows and/or moonroofs are opened. Al-
ways make sure that they are fully closed before
arming the system.

Disarming the system

Briefly press the "UNLOCK/DISARM" button (for less
than two seconds) on the remote transmitter. The driv-
er's door will unlock, an electronic chirp will sound two
6
times, the turn signal lights will flash two times and the
indicator light will go off.
To unlock all other doors (and the rear gate on the sta-
tion wagon), briefly press the "UNLOCK/DISARM" but-
ton a second time.
Emergency disarming
If you cannot disarm the system using the transmitter
UB2024CC
(i.e. the transmitter is lost, broken or the transmitter
battery is too weak), you can disarm the system with-
out using the transmitter.
To disarm the system:
Keys and doors
– CONTINUED –
2-17