Subaru 2004 Legacy Owner's Manual page 221

Audio
Tone control
The volume control dial (1) normally function as vol-
ume control. The dial become a control for Bass, Mid-
dle note or Treble when you select the appropriate
tone control mode.
Choose desired level for each mode by turning the vol-
ume control dial. The control function returns to vol-
ume control mode after about 5 seconds.
To change control modes: Each brief press of the
"AUDIO" button (2) changes control modes in the fol-
lowing sequence starting from bass control mode.
(When the radio is first turned on, the control mode is
in the volume control.)
Treble
Bass
Middle
(BASS) (TREBLE)
(MIDDLE)
Fader and balance control
The volume control dial (1) normally function as vol-
ume control. The dial become the controls for Fader or
Balance when you select the appropriate fader and
balance control mode.
Choose desired setting for each mode by turning the
volume control dial. The control function returns to vol-
ume control mode after about 5 seconds.
5-20
To change control modes: Each brief press of the
"BAL" button (3) changes control modes in the follow-
ing sequence starting from fader control mode. (When
the radio is turned on, the control mode is in the vol-
ume control.)
Fader
(FADER)
The brightness of the radio display dims when the light
switch is in the "
makes the display difficult to read, press the volume
Volume
dial for more than 1.5 seconds to return the display to
(VOLUME)
original brightness.
Subsequently pressing the volume dial again for more
than 1.5 seconds or if you can safely do so, turning the
light switch to the OFF position and back to the
"
dim again.
Push the "FM/AM" button (4) when the radio is off to
turn on the radio.
Push the "FM/AM" button when the radio is on to se-
Balance
(BALANCE)
Display illumination dimness cancellation
(BRIGHT)
" or "
" or " " position makes the radio display
FM/AM selection button (FM/AM)
Volume
(VOLUME)
" positions. If this