Install New Battery And Re-Install Battery Cover <= Ssr Task - IBM Power775 Service Procedure

Power775 Time of Day (TOD) Battery Service Procedure
3.3 Install new Battery and Re-install Battery Cover <= SSR TASK
Install the replacement battery into the battery slot by lining it up and pushing it into the
STEP 13
DCCA as seen in Figure 9. Note that the Plus side of the battery faces down. The tabs of the battery
holder will expand slightly as the battery slides into place. Be careful to note the orientation of the
battery; inserting the battery incorrectly will cause mechanical damage to the battery holder.
STEP 14 Verify that the new battery is seated tight to the back of the battery receptacle.
STEP 15 Reinstall the blue battery cover.
a) Engage the bottom tab of the blue battery cover into the DCCA.
b) Raise the top right corner of the blue battery cover so it encases the connector housing as seen
in Figure 10.
• Be careful to note the alignment of the left and right sides of the cover such that the
c) Ensure the blue battery cover is lined up correctly by raising the top left corner up, as seen in
Figure 11
d) Engage the top tab of the blue battery cover until it snaps into place as seen in Figure 12.
PN: 41U8496, EC N44172
Figure 9 Battery Replacement
cover is not shifted compared to the opening.
Figure 10 Replacing Blue Battery Cover
Page 13 of 23