Table of Contents
Advertisement
COM 2 PARAMETERS WHEN CANOPEN IS PRESENT
En. F buS.
FIELDBUS ENABLING
Enabling CANOPEN fieldbus, if OFF error messages concerning Fieldbus communication are never
displayed:
Values that can be selected:
OFF
ON
Default: OFF
Addr. C o
CANOPEN ADDRESS
Programming the address used in the CANOPEN protocol.
Values: from 0 to 126
Default: 1
Baud. C o. .
CANOPEN BAUD RATE
Defines the baud rate of the Canopen protocol.
The value must be set to the same value as the PC / PLC.
Values that can be selected (expressed in Kbit/sec.):
10
20
50
125
250
500
1000
Default: 20
Page 43
Advertisement
Table of Contents
Need help?
Do you have a question about the DAT11 and is the answer not in the manual?
Questions and answers