Table of Contents
Advertisement
To connect to the MASTER, use a standard twisted pair Ethernet
cable with RJ45 connector.
The RJ45 Ethernet connection cable has a variable maximum length,
depending on the type of cable. A common Cat5 shielded cable
can have a maximum length of about 180 m.
• You can connect the Ethernet communication port directly to the
PC, without having to go through other network devices (routers,
switches, hubs, LAN-bridge or the like), but special RJ45 cables must
be used, called "crossover."
• Normally cables are the "direct" type and allow connection to
network devices such as routers or hubs, but not direct connection to
two PCs (even if there are currently network cards with auto-sensing
technology, which recognize the type of
cable and the type of connection, allowing
direct PC-PC connections as well as using
non cross-over cables).
• On side are diagrams of the two types
of cables mentioned and their connection
diagram.
ETHERNET / IP CONNECTION
Ethernet / IP is a real-time industrial protocol which is based on the
Ethernet network.
There are two RJ45 connectors to allow connection of multiple instru-
ments in the same network.
Refer to the previous page for connection notes and warnings.
Features:
10 and 100 Mbit operation, Full and Half Duplex
Up to 128 bytes of I / O fieldbus in every direction.
1 2 3 4 5 6 7 8
PIN
DESCRIPTION
1
TX+
2
TX-
3
RX+
4
5
6
RX-
7
8
1 2 3 4 5 6 7 8
Page 9
Advertisement
Table of Contents
