Image Quality Defects - Oki Teriostar LP-1040 Series User Manual

Image Quality Defects

Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
Chapter
6
250
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
This section describes the action to solve printing quality problems. Take action as
appropriate for the symptom.
„ Action for Image Quality Defects
Symptom
Printing is too dark or light
Printing is partially missing
Black lines appear partially on
the printout.
TIP
‘ The Printer can be set to cut the top of the roll paper automatically
before the next printing operation if the Printer does not print for the
prescribed time or more between the current printing and the next
printing.
Cause
—————
The installed paper type and the
touchpanel setting's paper type do
not match.
The paper is moist.
The installed paper is not OKI Data
Infotech-specified.
The service life of the process
cartridge is coming to an end.
( & page 89, Top Cut Timer (Roll 1-2))
Action
Try adjusting the print density.
page 91
Replace the paper or change the
touchpanel setting. & page 46
or page 87
Cut off the top of the roll paper
installed in the Printer. & page 46
& page 42
Set the heater to On.
Install the OKI Data Infotech-specified
paper. & page 29
Replace the process cartridge.
page 65
&
&