Oki Teriostar LP-1040 Series User Manual page 51

6
Cutter
ロール紙の交換 1 2
Replacing Roll Paper
用紙カッ ト位置
Paper Cut Position
Caution
Be careful not to injure yourself on the cutter.
‹
Note
After closing a roll paper drawer, do not open it again until the Warming
‹
up... (Warming-up counter) message disappears.
‘ When you set a roll paper of a different type or series, press Paper on
TIP
the supply paper error screen. Set the type and the series of the new
paper roll on the paper setting popup screen which appears.
7
While holding the end of the roll paper,
cut the paper with the cutter.
The Paper Cut Position label is affixed to the
left end of the groove for the cutter edge.
3 4 5 6 7
Insert the edge of the cutter in the groove above
the label and cut the paper by moving the cutter
along the groove.
Close the roll paper drawer.
Hold the handle and slowly push in the drawer
for rolls 1 and 2. (It takes about 30 seconds for the
paper feeding to get ready.)
When the Printer contains the jobs to be
completed, the printing is started.
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
Replacing the Roll Paper
T
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
Chapter
6
51