Oki Teriostar LP-1040 Series User Manual page 144

Setup Items in PDL Settings Menu
T
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
Chapter
6
144
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
If the density of a thin line is reduced, it may be printed as a dotted line.
In the D-SCAN format, 16 gradations are available for printing.
Specified Values (%)
0 to 5
6 to 12
13 to 18
19 to 24
25 to 30
31 to 37
38 to 43
44 to 49
In the HP-GL format, printing is performed in white when the density is 0%.
z
In the D-SCAN format, printing is performed in white when the density is 0 to 5%.
z
z
Line End
The parameter specifies the line end shape for the printer's pens.
<Parameter by selecting options>
Round
n
Butt
The line end shape of these parameters are shown in the figures below.
z
Round
The printing may take time when the parameter settings are NOT as follows.
z
Line End to Round; and
Line Join to Round
The Line End parameter may not be valid for the outermost line on a drawing.
z
z
Line Join
The parameter specifies the line join shape of the Printer's pen.
<Parameter by selecting options>
Round
n
Mitered
The connection method of these parameters are shown in the figures below.
z
Gradation Specified Values (%)
1 50 to 56
2 57 to 62
3 63 to 68
4 69 to 74
5 75 to 81
6 82 to 87
7 88 to 93
8 94 to 100
: Default value
n
Sets the line end to round.
Sets the line end to butt.
a
: Default value
n
Sets the line join to round.
Sets the line join to mitered.
Gradation
9
10
11
12
13
14
15
16
Butt
a = 1/2 of line width