Oki Teriostar LP-1040 Series User Manual page 222

Smart Card Registration Procedure
Chapter
1
‹ Preparation 1
Chapter
2
Chapter
3
Chapter
4
‹ Preparation 2
Chapter
5
Chapter
6
222
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
(1) Install the smart card reader.
See the separate smart card reader leaflet for the installation procedure.
(2) Enable the smart card option.
See & page 156 for details on how to enter the option code.
(3) Configure the smart card settings.
See & page 162 for details on how to configure smart card settings.
The two following methods are available to register smart cards.
- Registration by the administrator with the user maintenance tool
- Registration by the users with the Printer
For details on the method using the user maintenance tool, see the
of the software.
The following describes the procedure to register smart cards with the Printer.
(1) Configure Smart card Registration.
Set Smart card Registration to Allow.
See Allow User Info Edit on
(2) Register a user.
& page 202
See for how to register users.
After this step, the smart card has not been registered yet.
(3) Configure User Authentication.
See User Authentication Setting Procedure on
After this step, PIN code authentication or password authentication can be used.
& page 208
for more details.
& page 205
User's Manual
for more details.