Table of Contents
Advertisement
7. To replace the lamp assembly, line up and insert
the tabs on the back of the assembly with the slots
in the fender. Engage the lower clip on the front of
the lamp assembly, keeping the upper tab on the
parking/turn signal lamp assembly inboard of the
headlamp bracket tab.
8. To align the parking/turn signal lamp assembly with
the headlamp assembly, lift up the parking/turn
signal lamp assembly until the upper edge
is
contacting the fender.
9. Fasten the parkinglturn signal lamp assembly to the
headlamp assembly with the thumb screw removed
in Step 1.
Taillamps
1. Open the liftgate.
2. Remove the two screws from the taillamp housing
on the inboard side.
3. Pull off the entire taillamp housing. The
locatorlretaining pins on the outboard side are
part of the lamp assembly and will remain intact
during removal.
6-37
Advertisement
Table of Contents
