Table of Contents
Advertisement
NOTE:
While this mode provides increased security, it
can be a problem if your remote keyless entry
transmitter
is
damaged, lost
or if
it fails to operate for
any reason while the Content Theft-Deterrent system is
armed. The Content Theft-Deterrent system must be
disarmed for the engine to run while in Mode 2; your
key can no longer disarm the system.
Mode 3: Standard Arming and Disarming
The system will arm when you lock the doors using
either power door lock switch while any door or the
liftgate is open and the key is removed from
the ignition.
your key or remote keyless entry transmitter and the
key is removed from
the
ignition.
The system will
arm
when you lock the doors with
The system will disarm when you unlock the doors
with your key or remote keyless entry transmitter.
Vehicles are delivered programmed in Mode 1.
To change the mode:
1. Follow the instructions for "Entering Programming
Mode" listed previously.
2. Insert your second key fully into any door key
cylinder and turn it to the unlock position.
This step is inconvenient, but necessary to prevent
accidental programming of this feature to Mode 2.
Do not program this feature to Mode 2 without first
reading the special note contained in the description
for that mode. The door key cylinder must remain in
the unlock position during Steps 2 through 4.
3. Press the horn symbol on the remote keyless
4. Count the number of chimes you hear. The
entry transmitter.
number of chimes tells you which mode your vehicle
is in. You can change the mode by pressing the
horn symbol on the remote keyless entry
transmitter again.
5. Repeat Step 3 until you hear the number of chimes
that matches the mode you want.
6. Remove your key from the door key cylinder.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
2-49
Advertisement
Table of Contents
