Table of Contents
Advertisement
If your vehicle is facing downward on a steep
grade (15 percent or more), the door may not
stay open and could slam shut, possibly injuring
someone. To make sure the door does not slam
shut, turn on the power sliding door feature.
Then if the door closes, it will close under the
control of the power door system.
To manually close the power sliding door when the
override feature is disabled, pull the inside or outside
handle or the edge of the door. Move the door about
4 inches (10 cm) toward the closed position and release.
The door will close completely and latch for you.
To manually close the power sliding door when the
override feature is enabled, pull the inside or outside
handle and slide the door all
the
way forward to the
latched position.
Resetting the Power Sliding Door
The power sliding door
may
operate incorrectly
or
not at
all because of the following conditions:
A low voltage or dead battery,
Disconnecting the battery or
If the IGN 1, B/U LAMP, RADIO or PWR
SEATPSD
fuse is removed or blown.
See "Fuse Panel" in the Index for more information
about your fuse panel.
If any of these conditions occur, the power sliding door
will need to be reset. To do this, follow the directions
listed here. It will be easier if you read through them
once
before beginning
this
procedure.
1. Check to be sure the power sliding door is unlocked
2.
Turn
the ignition switch to OFF.
3. Enable the power sliding door override feature.
4. Remove the RADIO fuse from the underhood fuse
and relay center. Leave it out for 30 seconds.
and securely closed.
5. Reinstall the fuse and wait 10 seconds.
2-19
Advertisement
Table of Contents
