Weighing System; M(26 Ft3 In) Drive Cut-Off (Floor Height) - Haulotte Compact 8 Operator's Manual

Electric scissor lifts
E
- Driving

3.1.4 - Weighing system

Check the overload limitation device every 6 following the procedure below :
• Position the machine on a flat and firm surface.
• Stow the machine completely.
• Retract the extensions.
• Use suitable handling equipment to position the test load (see table) in the centre of the platform.
Load table
Model
Compact 8 (Compact 2032E)
Compact 8 CU
Compact 8W (Compact 2247E)
Compact 10 (Compact 2747E)
Compact 10N (Compact 2632E)
Compact 12 (Compact 3347E)
• Pull the emergency stop switch- buttons (cut-off) (144, 46).
• Turn the ( 72 ) or ( 92 ) control box activation keyed selector switch to the right to energize the ground
control box.
• Activate the raising/lowering selector 106 upwards to lift the platform by 0,10 m (4 in) over the
specified upper transport position limit.
• Stop the movement.
• Check that the platform overload indicator ( 30 ) for the upper console is active and that a warning
signal (bip) is audible.
• If this result is not obtained, the overload limitation system must be restored to working order. Please
refer to the Maintenance book or contact HAULOTTE Services®.

3.1.5 - 8 m(26 ft3 in) drive cut-off (Floor height)

For C10RTE / C12RTE machine only :
72 2420332270
Test load
450 kg (992 lbs) Compact 14 (Compact 3947E)
400 kg (882 lbs) Optimum 6 (Optimum 1530E)
600 kg (1323 lbs) Optimum 8 (Optimum 1930E)
600 kg (1323 lbs) Compact 10RTE (Compact 2668RTE)
300 kg (662 lbs) Compact 12RTE (Compact 3368RTE)
400 kg (882 lbs)
Drive speed
1. Always ensure that the chassis is never driven any closer than 2 m(6 ft7
in) m to holes, bumps, tilts, obstructions, debris and ground coverings that
may hide holes and other dangers.
2. From the upper control panel, set the gear selector ( 112 ) to microspeed
position.
3. Raise the platform at 8 m(26 ft3 in) minimum (Floor height)
4. Push the movement joystick ( 108 ) forwards to move the machine
forwards
5. No travel movement has to be performed from the upper control panel.
e10 12
Model
450 kg (992 lbs)
350 kg (772 lbs)
300 kg (662 lbs)
750 kg (1654 lbs)
600 kg (1323 lbs)
Test load
EN