Activation Of Controls; Fault Detector; Buzzers Test; Overload Sensing System - Haulotte Compact 8 Operator's Manual

Hide thumbs Also See for Compact 8:
Table of Contents

Advertisement

Compact 8 (C 2032E) - Compact 8W (C 2047E) - Compact 10 (C 2747E) - Compact 10N (C 2632E) -
Compact 10N-1 - Compact 12 (C 3347E) - Compact 14 (C 3947E)
C
- Pre-operation inspection
4.2 -
A
CTIVATION OF CONTROLS
The enable switch must be actived to allow any movement.
The "Enable Switch" system depends on the machine configuration and will consist of one of
the following :
• Enable trigger on platform control joystick.
• Foot pedal (enable switch) in the platform.
• Enable switch at ground and platform boxes.
4.3 -
F
AULT DETECTOR
N.B.-:-T
The fault indicator LED flashes to indicate a malfunction.
The machine switches to downgraded mode.
Certain movements can be limited or forbidden to preserve the operator's safety.

4.3.1 - Buzzers test

Step
1
Pull the E-Stop buttons ( 144 ) at ground control box and ( 46 ) on the platform control box
Turn the control box activation selector key ( 92 ) to the left or right to activate a control box. An audible
2
signal (beep) sounds.
4.4 -
O
VERLOAD SENSING SYSTEM
The overload limitation system activates if the heights defined in the "Transport position
maximum height" table are exceeded (
If the platform load exceeds the maximum allowed load, no movement is possible from the 2
control boxes.
At ground and platform control boxes a buzzer sounds and an indicator light warns the opera-
tor.
To return the machine to normal operation remove weight from the platform until the load is
below the maximum allowed load.
Daily check that the LED's illuminate when the machine is switched on :
• Verify that the Overload system is active : Refer to Indicators ( 6 ) at ground and ( 30 ) at
platform.
• Verify that the buzzers are functioning : Refer to Buzzers test
A periodic inspection of this device must be performed according to the recommendation in
Maintenance Schedule.
68
4001001030
HE PRESENCE OF THIS DEVICE DEPENDS ON THE MACHINE CONFIGURATION
From the ground control box
Action
Section C 4.6 - Travel speed limitation).
E 06.20
.
USA / GB

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents