Operation; Test Procedure; Emergency Stop Switch- Button Function (Cut Out); Tilt Sensor Switch Operation - Haulotte Compact 8 Operator's Manual

Electric scissor lifts
E
- Driving

3 - Operation

N.B.-:-The functions are described for the entire range. Refer to the machine model to identify the
controls and functions indicators.
Find all the function indicators and controls in
3.1 -

TEST PROCEDURE

3.1.1 - Emergency stop switch- button function (cut out)

Ground control box emergency stop button
Step
1
2
3
4
Platform control box emergency stop button
Step
1
2
3
4

3.1.2 - Tilt sensor switch operation

Machine unfolded, the slope sensor gives an audible signal telling the operator that the machine should
not be deployed. In this case, fully lower the platform and reposition the machine on level ground before
raising the platform again.
N.B.-:-Depending on your machine configuration, outside assistance may be necessary in order to carry
out this operation.
70 2420332270
Pull the emergency stop switch- buttons (cut-off) 144, 46
Switch the machine on 72 or 92(Depending on the machine).
Turn the ( 72 ) or ( 92 ) control box activation keyed selector switch to the right to energize the
ground control box(Depending on the machine). The indicators light up.
Push the emergency stop switch- push button (cut-off) 144. The indicators go out.
Pull the emergency stop switch- buttons (cut-off) 144, 46
Switch the machine on 72 or 92(Depending on the machine).
Turn the ( 72 ) or ( 92 ) control box activation selection key to the left to activate the platform
control box(Depending on the machine). The indicators light up.
Push the emergency stop switch- push button (cut-off) 46. The indicators go out.
1. Pull out the emergency stop switch-push buttons (cut-out) on the upper and lower
control boxes (144, 46).
2. Switch on the machine from the lower control box (72) or (92)(Depending on the
machine).
3. Locate the tilt sensor next to the ground control box.
4. Manually tilt and maintain the tilt sensor towards the front for a few seconds
( Section C 2-Main components) :
5. The audible beep sounds.
6. For machines fitted with : The slope sensor prevents lifting and driving movements.
Section C 5 - Control boxes
Action
Action
e10 12 EN