Table of Contents
Advertisement
Engine-powered scissor lifts
E
- Driving
3.1.2 - Tilt sensor switch operation
Machine unfolded, the slope sensor gives an audible signal telling the operator that the machine should
not be deployed. In this case, fully lower the platform and reposition the machine on level ground before
raising the platform again.
N.B.-:-Depending on your machine configuration, outside assistance may be necessary in order to carry
out this operation.
3.1.3 - Visual and sound alarms
3.1.4 - Weighing system
3.2 -
OPERATION FROM GROUND POSITION
Ground control box is an auxiliary to be used only in case of emergency.
3.2.1 - Machine start-up
66
4000014860
1.
Pull the emergency stop push-buttons on the upper and lower control boxes (15, 46).
2.
Switch on the machine from the lower control box (72).
3.
Locate the tilt sensor next to the ground control box.
4.
Manually tilt and maintain the tilt sensor towards the front for a few seconds
(
Section C 2-Main components) :
5.
The audible beep sounds.
6.
For machines fitted with : The slope sensor prevents lifting and driving movements.
1.
Pull the emergency stop buttons (15, 46).
2.
Select the upper console (72). The indicator ( 31 ) of the control box lights up, and there
is audible signal (beep).
1.
Pull the emergency stop buttons (15, 46).
2.
Select the upper console (72). Platform control box overload indicator (85 : Compact /
30 : HSX(L)) flashes.
1.
Pull the emergency stop button (15).
2.
Turn the key on the control box activation selector switch ( 72 ) to the right to energize
the ground control box. The following indicators light up :
• Electrical pre-heating (1).
• Engine oil pressure (2).
• Engine temperature (3).
• Battery charge (4).
3.
For HSX(L) : The clogged air filter indicator ( 5 ) is switched off.
4.
For HSX(L) : Press on the starter selector (22). For Compact DX : Push the selector
upwards (123). The engine starts. The indicators go out.
5.
Let the engine heat up.
e10 12
EN
Hide quick links:
Advertisement
Table of Contents
