Loading And Unloading; Principle; Loading By Ramp; Unloading By Ramps - Haulotte Compact 8 Operator's Manual

Electric scissor lifts
F
- Special procedure

3 - Loading and unloading

3.1 -

PRINCIPLE

3.1.1 - Loading by ramp

To avoid any risk of sliding during loading, ensure that :
• The loading ramps can bear the load.
• The loading ramps are correctly attached.
• The loading ramp has sufficient grip.
To climb the slope, select low driving speed
If the slope is too steep, use a winch in addition to traction.
Never place yourself below or too close to the machines during loading.
A wrong move can lead to the tipping over of the machine and cause serious bodily and material accidents.

3.1.2 - Unloading by ramps

Before operating, check that the machine is in good condition.
If the machine has been damaged during transportation, contact the transporter in writing

3.1.3 - Loading by lifting

Ensure that :
• The machine is completely stowed.
• The platform must be empty.
• The lifting equipment ie. slings, shackles, hooks, lifting beam etc. are in good condition and of
sufficient capacity.
• The personnel performing the lift is authorised to complete the lift.
3.1.4 - Loading by lifting
Prohibited
82 2420332270
1. Remove the tie downs.
2. Start the machine.
3. The lifting equipment ie. slings, shackles, hooks, lifting beam etc. are in good condition
and of sufficient capacity.
4. The personnel performing the lift is authorised to complete the lift.
(or ).
e10 12 EN