P2 Card Recording Time - Panasonic AJ-PX5100G Operating Instructions Manual

Memory card camera-recorder

page of 263

/ 263
Contents
Table of Contents
Bookmarks

Table of Contents

P2 card access LED

Off

* The mode check is displayed on the viewfinder screen. For details, refer to "Viewfinder status display" (page 102).

P2 card recording time

r P2 cards supported on the camera

The optional P2 memory cards and microP2 memory cards with a capacity of 30 GB to 64 GB can be used with the camera. (As of December 2018)

NOTE

t 2 GB cards cannot be used.

t When AVC-Intra 200 and AVC-Intra 100 in 1080/59.94P or 1080/50P mode are selected, you cannot record to the following P2 cards.

- P2 memory cards of R, A, or E series

- microP2 memory card to which microP2 adaptor is attached

t The driver installed on the camera may be required to be updated depending on the type of P2 card. (page 253)

t Refer to our support desk at the following website for the latest information not included in these operating instructions.

https://pro-av.panasonic.net/

r P2 card recording times

(Example when a 64 GB card is used)

System mode

1080P

1080i, 720P

480i, 576i

NOTE

t The above table shows values for regular recording. With native recording, even longer recording times are available depending on the system mode.

t Indicated capacities include management and other area, so the space available for recording is less than the values in the table above.

Dividing clips recorded on P2 cards

The recording is automatically continued as another clip when a single continuous recording time exceeds the following time, if a P2 card with a capacity

of 8 GB or larger is used on the camera. it can be operated as a single clip when the thumbnail operation (displaying, deleting, restoration, etc.) on the

P2 device is performed. Clips may be displayed as separate clips in nonlinear editing software or on a computer. When recording on a microP2 memory

card that exceeds 32 GB in AVC-LongG codec, the recording can be continued as a same clip by selecting [ONE FILE] from the main menu → [REC/

PB] → [REC/PB SETUP] → [FILE SPLIT]. Also, the clip will be divided into recording file of approximately 128 seconds each when the main menu →

[REC/PB] → [REC/PB SETUP] → [FILE SPLIT] is set to [SHORT SPLIT], but it can be operated as a single clip when the thumbnail is operated on the

P2 device. The divided unit of the recording file becomes smaller when [SHORT SPLIT] is selected, making the transfer of the clip to start earlier when

the rec during upload function is used.

[SHORT SPLIT] is disabled during the interval recording, the one-shot recording, and the loop recording.

Recording format (excluding native recording)

AVC-Intra 200 (1080i)

AVC-Intra 100 (1080P)

AVC-Intra 100 (1080i)

Chapter 3 Preparation — P2 card

Card not supported

Illegal format

No card

Unauthenticated card

USB non-access