Table of Contents
Advertisement
[MONI OUT MARKER]
Item
[CENTER MARK]
[SAFETY MARK]
[SAFETY AREA]
[FRAME MARK]
[FRAME SIG]
[USER BOX]
[USER BOX WIDTH]
[USER BOX HEIGHT]
[USER BOX H POS]
[USER BOX V POS]
[DOWNCON SETTING]
Item
[DOWNCON MODE]
[DETAIL]
[H.DTL LEVEL]
[V.DTL LEVEL]
[DTL CORING]
[H.DTL FREQ.]
Chapter 6 Menu Operations — Menu list
Switches the center marker.
[1]:+(large)
[2]: Open center (large)
[3]: +(small)
[4]: Open center (small)
[OFF]: Does not display.
f Factory setting: [1]
Selects the type of frame for the safety zone marker.
[1] Box
[2] Corners
[OFF] Does not display.
f Factory setting: [2]
If the main menu → [I/F SETUP] → [DOWNCON SETTING] → [DOWNCON MODE] is set to [SIDE CROP]
or [LETTER BOX], the safety zone marker is not displayed to the down converter output signal in HD
mode.
Sets the size of the safety zone marker.
The constant ratio of length to width can be set in 1% increments.
[80%]...[100%]
f Factory setting: [90%]
Enables/disables frame marker.
[ON], [OFF]
f Factory setting: [OFF]
Sets frame marker aspect ratio.
[4:3], [13:9], [14:9], [VISTA], [CNSCO]
f Factory setting: [4:3]
[VISTA] is 16:8.65, and [CNSCO] is 16:6.81.
Sets whether to display the user box to the signal from the monitor output terminal (<SDI OUT2>, <HDMI
OUT>, or <VIDEO OUT>).
[ON], [OFF]
f Factory setting: [OFF]
If the main menu → [I/F SETUP] → [DOWNCON SETTING] → [DOWNCON MODE] is set to [SIDE CROP]
or [LETTER BOX], the user box is not displayed to the down converter output signal in HD mode.
Sets the width of the user box.
[1]...[100]
f Factory setting: [13]
Sets the height of the user box.
[1]...[100]
f Factory setting: [13]
Sets the horizontal position of the center of the user box.
[−50]...[50]
f Factory setting: [0]
Sets the vertical position of the center of the user box.
[−50]...[50]
f Factory setting: [0]
Sets the mode of the down converter output signal.
[SIDE CROP], [LETTER BOX], [SQUEEZE]
f Factory setting: [SQUEEZE]
When [LETTER BOX] is selected, some parts of the top and bottom edges of the down converter output
video may be distorted. This is not a malfunction.
Turns detail function for the down converter output signal [ON]/[OFF].
The down converter output signal contains detail components set during HD signal processing.
This setting superimposes the detail components exclusive to down converter output to that signal.
[ON], [OFF]
f Factory setting: [ON]
Even if this setting is [OFF], the detail components set during HD signal processing cannot be disabled.
Sets horizontal detail correction level for the down converter output signal.
[0]...[31]
f Factory setting: [8]
Sets vertical detail correction level for the down converter output signal.
[0]...[31]
f Factory setting: [4]
Sets the detail noise removal level.
[0]...[15]
f Factory setting: [1]
Selects the horizontal detail frequency.
[2.5MHz], [3MHz], [3.5MHz], [4MHz], [4.5MHz]
f Factory setting: [3.5MHz]
– 184 –
Description of settings
Description of settings
Advertisement
Table of Contents
