Table of Contents
Advertisement
Chapter 2 Description of Parts — Power supply and accessory mounting section
Power supply and accessory mounting section
9
2
3
4
5
6 7
1 <POWER> switch (page 56)
Turn the power to on/standby.
To turn on, set the power switch to < j > (ON). To set to standby, set the power switch to < h > (standby).
@
NOTE
t Even when the <POWER> switch is set to the < h > (standby) position, the camera is not shut off from the main power.
2 Viewfinder left/right positioning ring
To adjust the left/right position of the viewfinder, loosen this ring, and slide the viewfinder to the left or right to adjust it to an easy-to-view position.
After adjustment, turn in the <LOCK> direction and firmly clamp.
3 <VF> terminal
Mount the viewfinder AG-CVF15G (optional), AJ-CVF50G (optional), etc.
4 Mount cap (page 35)
Raise the lens lever to remove the cap. Replace the cap when the lens is not mounted.
5 Lens cable/microphone cable clamp (page 35)
Used for securing the lens and microphone cables.
6 Lens mount (2/3-type bayonet) (page 35)
Mount the lens.
7 Tripod mount (page 42)
Attach the optional tripod adaptor (SHAN-TM700) when mounting the camera on the tripod.
8 Lens lever (page 35)
After mounting the lens to the lens mount, tighten the lever to secure the lens.
9 <LIGHT> switch
Select how to turn on/off the video light connected to the light output terminal.
When the video light is left turned on, the light is illuminated at the same time that recording starts on the camera and goes out at the
<AUTO>
same time that recording stops.
<MANUAL>
The light is illuminated according to whether the video light is turned on/off.
10 Shoulder strap fittings (page 42)
Attach the shoulder strap.
11 Battery release lever (page 32)
Pull this battery release lever down to release the battery.
12 Battery holder (page 32)
Mount the Anton/Bauer battery.
13 <DC IN> terminal (page 33)
This is the input terminal for the external power supply. Connect to the external DC power supply.
14 <DC OUT> (DC power supply) output terminal (page 44)
This is the DC12 V output terminal. It provides a maximum current of 1.5 A.
@
NOTE
t Make sure that polarity is correct before connecting an external device. Doing so may result in a malfunction.
15 <REMOTE> terminal (page 221) (page 222)
f Connect the extension control unit AG-EC4G (optional) to remote-control some functions. For details, refer to "Connecting to the extension control
unit (AG-EC4G)" (page 221).
19
10
8
1
11
12
13
14
15
– 17 –
16
17
18 10
22
19
20
21
Advertisement
Table of Contents
