Table of Contents
Advertisement
[HIGH SETTING]
Item
[[S] MASTER GAIN]
[H.DTL LEVEL]
[V.DTL LEVEL]
[DTL CORING]
[H.DTL FREQ.]
[LEVEL DEPEND.]
[MASTER GAMMA]
[BLACK GAMMA]
[B. GAMMA RANGE]
[[S] MATRIX TABLE]
[[S] COLOR CORRECT]
@
NOTE
t When saving or reading setup files from an SD memory card, you can save items with an [S] and items without an [S] separately. Items with an [S] in
front of the item name are the targets for [PAINT([S]SELECT)] in the main menu → [FILE] → [SETUP DATA SELECT]. Items without an [S] are targets
for [PAINT(LEVEL)].
t [−6dB] in [[S] MASTER GAIN] cannot be selected when [NORMAL] is set in main menu → [PAINT] → [[S] CAMERA SETTING] → [SHOOTING
MODE].
[ADDITIONAL DTL]
Item
[KNEE APE LVL]
[DTL GAIN(+)]
[DTL GAIN(−)]
[DTL CLIP]
[DTL SOURCE]
[MASTER DTL]
Chapter 6 Menu Operations — Menu list
Selects the master gain.
[−6dB], [−3dB], [0dB], [3dB], [6dB], [9dB], [12dB], [15dB], [18dB], [21dB], [24dB], [27dB], [30dB]
f Factory setting: [12dB]
Sets the horizontal detail correction level.
[0]...[63]
f Factory setting: [6]
Sets the vertical detail correction level.
[0]...[31]
f Factory setting: [10]
Sets the detail noise removal level.
[0]...[60]
f Factory setting: [12]
Selects the horizontal detail frequency.
[0]...[31]
f Factory setting: [18]
Sets the [LEVEL DEPEND.].
Compresses the details of dark areas when Y detail is emphasized.
Details of bright areas are also compressed if the value is large.
[0]...[5]
f Factory setting: [1]
Sets the master gamma in 0.01 steps.
[0.30]...[0.75]
f Factory setting: [0.55]
Sets the gamma curves of dark areas.
[−8]...[−1]: Compresses the dark areas.
[OFF]: Standard state
[1]...[8]: Expands the dark areas.
f Factory setting: [OFF]
Sets the maximum level of compression/expansion.
[1]: About 20%
[2]: About 30%
[3]: About 40%
f Factory setting: [1]
Selects the color collection table for the linear matrix.
[A], [B], [OFF]
f Factory setting: [A]
Switches the 15-axis independent color correction on/off.
[ON], [OFF]
f Factory setting: [ON]
Changes the detail level of high-brightness areas.
[OFF], [1]...[5]
f Factory setting: [2]
Changes the level of + (upper) direction of detail.
[−31]...[31]
f Factory setting: [0]
Changes the level of − (lower) direction of detail.
[−31]...[31]
f Factory setting: [0]
Sets the level at which detail signals will be clipped.
[0]...[63]
f Factory setting: [0]
Sets the ratio of RGB signal components that will create the detail.
[(R+G)/2], [(G+B)/2], [(2G+R+B)/4], [(3G+R)/4], [R], [G]
f Factory setting: [(R+G)/2]
Changes the master detail level.
[−31]...[31]
f Factory setting: [0]
– 160 –
Description of settings
Description of settings
Advertisement
Table of Contents
